iMX6 DualLite Development Kit


What is included when buying a kit?

  • iMX6 DualLite COM board
  • COM Carrier board
  • One Molex Micro-Fit 3.0 2-pos connector with 3 cm cables
  • One Molex Micro-Fit 3.0 10-pos connector with 30 cm cables
  • One micro-B to A USB Cable
  • One FTDI cable (UART-to-USB bridge for console output)
  • One Debug interface board with 10-pos FPC cable
  • 12V/2A power supply (has interchangeable AC plug for EU, UK, US, AUS, KOR and CHN)

iMX6 DualLite Development Kit

The Embedded Artists iMX6 DualLite Development Kit lets you get up-and-running quickly with the The iMX6 DualLite COM Board. All relevant interfaces are available for evaluation or prototyping.
  • Evaluate the iMX6 DualLite COM board
  • All relevant interfaces are available
  • Easy to add RF solutions

iMX6 DualLite COM

  • 3D and 2D graphic engines
  • Hardware accelerator for video encoding/decoding
  • 2x Cortex-A9 @ 1 GHz

Connectors and Interfaces

  • MXM3, 314-pos connector with standoffs for COM boards
  • Dual 10/100/1000 Mbps Ethernet RJ45 connectors
  • USB OTG interface with ESD protection
  • Dual USB Host interfaces (via USB Hub) with ESD protection
  • HDMI connector with ESD protection
  • uSD/MMC connector (MMC is in parallel with uSD, so either one can be used but not both)
  • Dual CAN transceivers with ESD protection and optional termination, accessible via Molex Micro-Fit 3.0 connectors
  • SATA connector
  • Internal UART connectors (compatible with FTDI cables)
  • XBee™ compatible interface connector
  • Mini PCIe connector for half and full-size cards, including SIM card holder and USB interface
  • FPC connectors for serial and parallel camera interface and serial display output (MIPI-DSI)
  • Dual LVDS connectors
  • Parallel RGB display interface connector
  • Expansion connectors for many COM Board signals
  • Audio codec with line out 3.5mm audio jack connector (with internal connector for microphone and line input and headphone output)


  • 12V (+-30%) supply voltage, either via internal ATX connector or via external Molex Micro-Fit 3.0 connector
  • Reverse polarity protection
  • Internal 3.3V/4A and 5V/3A (and 3.3V/3A for PCIe) DC/DC converters with high efficiency
  • Li-Ion / Li-Polymer battery charger for COM board RTC (note: battery not included)


  • 165 x 104 mm (same size as a typical 7 inch LCD).
  • Five M3 holes for mounting and grounding


  • On/Off and Reset pushbuttons
  • Input current measurement

Product Classification

  • Evaluation board

Development Kits

Use Embedded Artists’ Development Kits as your evaluation/prototyping platform. The kit includes the hardware and software components needed to get up-and-running with your software development on day 1.


Note: the used COM board must support the specific interface to make use of the carrier board interfaces/connectors.